Hycote Lens Smoke Spray Paint 400ml

Hycote XUK436 Lens Paint Smoke 400ml

Hycote speciality paints cover areas other paints don't, from front brake calipers to truck beds.The bright finishes of the fluorescent range add enhanced viability to surfaces.

• Transparent lacquer
• For customising lights
• Professional results
• Scratch Free and Shock Proof
• Resistant To Petrol, Chemicals and Weather Influences
• Good Adhesion Properties
• Lasting Gloss Effect
• Easy To Apply
• Does No Harm to Backlight
• One 400ml Spray Can Will Cover 8 Backlights (Approximately)
• Dust Dry: 5 to 10 Minutes
• Tack Free: 10 to 20 Minutes
• Hardened / Re-sprayable: After 2 Hours

How to Use:

1. Ensure that the surface of application is clean, dry and free of grease.
2. Before use, shake the aerosol for 2 minute. Ensure a distance between the spray and surface to be treated of approximately 25cm to 30cm.
3. Spray the lacquer in several thin layers, until the desired result has been achieved. Before applying each layer, again shake the aerosol.
4. After use, clean the valve. Turn aerosol upside down and press the nozzle for approximately 5 seconds.
5. Wait for the lacquer to dry. The drying time depends on the ambient temperature, the humidity of the air and the thickness of the lacquer applied.

Please note:

Due to printing limitations, the colour may vary from the cap and can colour.

400ml Cans have 100ml paint and 300ml propellant. It will do approx. 1m2 of one coat.

200ml Cans have 50ml paint and 150ml propellent. It will do approx. 0.5m2 of one coat.

The above estimates are based on using a primer first especially on porous surfaces where the paint gets absorbed into the material.

We recommend using a primer then paint followed by clear lacquer for best results. Always try on a small area first before spraying the whole area.